Corvette style regulator / filter question

[92yukon]

How do i go about connecting the feed and return from a Corvette style regulator / filter back to the stock fuel lines on my 96 Tahoe ? Are guys just using injection rated hose and clamps ?

 

[5.3_silverado]

I'm using nylon fuel line for mine. Simple and cheap and last a long time

 

[Knuckle Dragger]

Yep, make the nylon lines.

http://www.amazon.com/Dorman-800-300-Nylon-Repair-Piece/dp/B000XQ5IO4

If you look around enough you can generally find that kit for $100 or so.

 

[92yukon]

That kit is expensive, do i need the included tool to make lines ?

 

[92yukon]

Also looking at this on summit the hose comes in (3/8 OD - 5/16 ID) and (5/16 OD - 1/4 ID) are these the sizes i need ? I was assuming 3/8 ID was needed for feed and 5/16 ID was needed for return. Thanks

 

[5.3_silverado]

Mine cost 50 bucks for 30 feet. And the fittings.

 

[92yukon]

Mine cost 50 bucks for 30 feet. And the fittings.

From where and what size line did you use

 

[5.3_silverado]

From where and what size line did you use

Amazon. You will need to get the fittings to.

You must be registered for see images attach

 

[5.3_silverado]

Here the return line. 5/16.

You must be registered for see images attach

 

[92yukon]

Mine cost 50 bucks for 30 feet. And the fittings.

That's the one I asked about in the post above. 3/8 is the outer diameter but the inner is 5/16, you used this as your feed or return line, or both ?