richclemson
Newbie
The previous owner had the driver floor repaired, but when they cut the carpet away, it was never replaced. Pulling the seats out and tearing out the carpet showed a hole in the passenger side floor board.
Cleaned it up, and bent and cut a piece of sheet metal to fit the hole.
Found another small hole and welded a cover in place.
With the holes drilled all around the edges, I welded the panel in place.
I painted the entire floor in POR15 and smeared seam sealer on the edges. Then covered the floor in Dynamat Xtreme.
Sent from my iPad using Tapatalk
You must be registered for see images attach
Cleaned it up, and bent and cut a piece of sheet metal to fit the hole.
You must be registered for see images attach
Found another small hole and welded a cover in place.
You must be registered for see images
With the holes drilled all around the edges, I welded the panel in place.
You must be registered for see images
I painted the entire floor in POR15 and smeared seam sealer on the edges. Then covered the floor in Dynamat Xtreme.
You must be registered for see images attach
Sent from my iPad using Tapatalk