Could you take some pictures of the circuit board for me? I want to do it too, but all the pictures I've seen are too small!
And your 'Hoe is SO DAMN CLEAN! I love it.
Thanks bro, here is a copy of the thread I used to do mine. It is from another forum site I belong to.
Here is the thread, took a while to find. I had to dig deep to find this but here it is. This is not my write up.
Ok I just did this mod and snapped a few pics along the way :eyecrzy:
Went from this:
You must be registered for see images attach
To this:
You must be registered for see images attach
1st step get the lights out of the truck
You must be registered for see images attach
2nd I located a place where i could solder in to the curcuit board. I took a knife to open up the spots a little bigger:
You must be registered for see images attach
Then I soldered 2 wires to the curcuit board (sorry the pics a a bit blurry):
You must be registered for see images attach
You must be registered for see images attach
Then I routed the wires up the curcuit board and soldered them to the "bright" side of the upper bulb (should be the outer contacts on the bulb):
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
Make sure when you route the wires that they aren't under the seal (to pervent leaks) or against the bulbs cause they do get hot!
Sent from a Phone Booth using Tapatalk