Search results

  1. chevyman("

    Cammed vortec doesnt start without opening throttle!?!

    Hi i have a mildly built 350 vortec .30 over h beams forged crank 10.1 CR 500 lift cam 220/224 110lsa cam and it will not start without applying throttle if i hit the key it will bump a few times then die right after! Need some help guys i swapped the 0411 into it and lexitech hooked me up with...
  2. chevyman("

    Need some opinions on my built 350 vortec!

    Hey guys i just finished building a 350 vortec for my truck.. Long story short i have 0.30 speed pro flat tops in it its calculated out to be 9:91 so i think basiclly 10:1 compression would i be ok running 93 octane from experience does a 10:1 motor run pretty good on pump gas? 93 of course...
  3. chevyman("

    0411 swap ?

    Has anyone else had the one ground wire that just makes a loop it has 2 ends yellow and black it shows it to be pinned in pin 1 of c2.. So i just ground this one? Vortec powered iphone:D
  4. chevyman("

    From blackbox to 0411??

    Hey guys i have a 98 silverado l31 bored .60 eagle rods stock crank marine cam 1:6 rockers lil port an polish.. 4:10 gears.. E fan and lots of goodies also a tune, What would the 0411 do for me besides a higher rev limiter dual tables etc with all the mods i have? Vortec powered iphone:D
  5. chevyman("

    98 silverado long tubes

    98 silverado l31 i jave flotech shorties right now and im really wanting some longtubes because i know theyll help me but i only have the sensors on bank 1 an 2 no EGR or rear 02 sensor.. Will any.. Any of the older headers for c10's and such or something fit in my truck.. I can weld o2 bungs...
  6. chevyman("

    Flexplate ticking

    Hey guys, 98 silverado l31/4l60e I put a trans in it about a month ago and ever since its had this periodic tick/rattle noise coming for sure from the bellhousing area.. It only does it at idle to about 1000-1500 rpm if i hit the gas a sec i can usually make it do it but not always.. Is my...
  7. chevyman("

    she wonders on the road??

    hey guys 98 silverado extended cab i have 22 inch boss 304's with 305/40/22's and it likes to wonder the road when the road is uneven?? but with my stocks i can let the steering wheel go forever and itll still be going straight??
  8. chevyman("

    crown vic e fan setup

    hey guys, 98 silverado, l31, ive had my crown vic setup for about 6 months and its been working flawlessly but ive been running the high speed side the whole time.. my question is can i run the low side( the one running through the resistor) to my a/c compressor clutch + so the fan runs on low...
  9. chevyman("

    Lt4 hotcam in my 98... Ive searched!

    Hey guys i have a 98 with the l31 bored 0.60 over, marine cam, long tubes, roller rockers, bb tune, efans, and shes already pretty nasty with my 4:10 gears but im wanting a beefier cam now and im really really leaning toward the lt4 hotcam.. Ive searched and read and looked but i want some of...
  10. chevyman("

    Custom traction bars

    Ive been wanting some traction bars and i figured id build me a pair and wow they actual make a big difference! My truck feels so much more solid in the rear end! :D Vortec powered iphone:D
  11. chevyman("

    Limp mode HELP guys!!

    I believe my trans is in limp mode guys this is what it does.. No first gear at all period.. Starts in 3rd gear while in D Can manually shift to 2nd to start of then put it in drive an it shifts 3rd them 4th them lock up When i WOT it it will only downshift to 3rd period.. Plz help guys shes...
  12. chevyman("

    Guys need help NOW!!

    Will a 93-95 tranny work in my 98? Ive put a 98 tranny in a 95 before? But right now my truck has no 1st gear and it starts of in 3rd gear will in drive.. An if i WOT it she doesnt downshift... Shifts from 2nd 3rd 4th lockup is fine thou bu it only will downshift to 3rd no lower Sent from my...
  13. chevyman("

    Exhaust setup on roll pan?

    Hey guys 98 silverado ex cab ive had a roll pan and im tired of my plain ole dumped exhaust can i get some pics of a roll pan exhaust set up if you guys have any that would be the bomb.com! Sent from my iPhone using Tapatalk - now Free
  14. chevyman("

    2500 stall on my DD

    Hey guys i searched but didnt really see much i have a 98 silverado ex cab 5.7 bored 0.60 marine cam CAI shorties with full exhaust back 4:10 gears 31" tires and i just got my self a 2500 stall Sent from my iPhone using Tapatalk - now Free
  15. chevyman("

    Tc unlocking and locking?

    Hey guys 98 silverado 5.7 vortec 4l60e while im just cruising holding the pedal in one place sometimes my tc locks and unlocks like on off on off on off over and over until i hit the gas harder or let off is this my tc lock up solenoid?? Sent from my iPhone using Tapatalk - now Free
  16. chevyman("

    Trucks revs slow??

    When I wanna rev it it raps up quick but seems to take forever and a million years to come back on down is this because of all my accessories and big tc being a lot of mass and making it take a while to come back down on rpm Sent from my LG-LS840 using Tapatalk 2
  17. chevyman("

    Burnout pics/videos thread...

    Hey guys I feel like we need a burnout thread! We all have a side where you wanna just do a smokey burnout lol so let's see some pics or videos! Just for fun! Sent from my LG-LS840 using Tapatalk 2
  18. chevyman("

    Won't stay in 1st for burnouts?:p

    Hey guys when I put my shift in 1st gear most the time when I mash it it will still shift to second gear?? What the heck lol why does it do that? Safety for redline or ?? Sent from my LG-LS840 using Tapatalk 2
  19. chevyman("

    How's this pattern look??

    My backlash is at 0.06 Sent from my LG-LS840 using Tapatalk 2
  20. chevyman("

    180 thermostat in 98 silverado??

    Do I need to retune for a 180 thermo? Its running a lil better to be honest wit throttle response but should I still retune? Sent from my LG-LS840 using Tapatalk 2
  21. chevyman("

    a/c problem?????

    98 silverado l31-My compressor only kicks on when it wants to.. and it shuts off randomly when my a/c is on my freon is correct.. it cools excellent when the compressor is running.. compressor is new.. only thing I can think of is the stupid a/c controls in my dash I grabbed em from the junkyard...
  22. chevyman("

    What wheels are these?

    ?? Lol Sent from my LG-LS840 using Tapatalk 2
  23. chevyman("

    Custom hangers?

    Is it possible to take the rivets off the hangers and move them up am drill new holes with bolts? Sent from my LG-LS840 using Tapatalk 2
  24. chevyman("

    I realllly need your guys opinions!!

    Hey guys I installed a roll pan and I built a custom hitch and mounted it I need yall guys to give me ideas on if it looks strong enough the way I set it up plzz.. Sent from my LG-LS840 using Tapatalk 2
  25. chevyman("

    Long tubes on my vortec

    Hey guys I've been searchin I know what's out there but I'm just wondering what you guys think about 2.5 inch off the collectors y piped into a 3 inch to a single in dual out 40 series will that work for my 350 and sounds good and be beneficial with my long tubes Sent from my LG-LS840 using...

Latest posts

Staff online

Members online

Total: 1,126 (members: 24, guests: 1,102)

Forum statistics

Threads
64,620
Messages
1,397,594
Members
52,109
Latest member
Thorud74

Share this page

Top