So forgive my ignorance but my 99 Yukon (California rig) obviously has an aftermarket Muffler because it says MagnaFlow on it but I'm not sure about the rest of it. it has two small welded in catalytic converter looking things one on each pipe before the pipe turns into one and heads for the...
I had a development late last night I had my wife start it while I had my head under the hood and it actually did it while I was looking at it! I noticed the injector on the left side was not spraying anything and it was running like crap and as soon as I wiggled the plug-in on top of the...
Something like that sounds like it makes sense. It only tends to do it after you have been driving and you stop and let it sit for 20 minutes or so but not if you just shut it off then started right back up.
I have a problem I have battled for years now I drive my truck only every week or two but when you start it up it just barely chugs and will only stay running if you are giving it throttle but it has no power and runs like crap for approximately two minutes from the time you started then it...
Offroad design offers a one-inch zero rate ADD A LEAF to give you some lift without the negative effects of a block or a stiffer ride and you can move the axle an inch forward or back if you want to with it. If you need something for hauling heavier loads in my opinion air bags are better...
I have a 88 Chevy with the 454 and I'm thinking about cutting the exhaust behind the muffler but before the cat and dumping it down to make it sound maybe better does anybody have this set up does it sound better or help anything I'm thinking I could just save the rest of the system and weld it...
I'm thinking of making my own 1 or 1.5 inch body lift, if I only go that high can I avoid having to do anything to the shift linkage and gas filler tube and fan shroud? I want a little extra lift beyond what I got out of my torsion bars but don't want the goofy look of a big body lift
I want to to swap out my power everything doors from my extra cab 88 k3500 and put some manual everything doors from a reg. Cab 89 k2500 donor truck. Will the doors fit? Also can I just disregard all the wiring that went to the power junk or will other things quit working if those wires are left...
that's a good idea I remember hearing about the paper clip thing but I couldn't remember exactly what you were supposed to do so that will be helpful it actually does not start hard but it does run like poop for a minute after you get it started then it clears up all of a sudden and the check...
After the truck has been running for a long time and you shut it off when i restart it runs horrible (like its being choked out or something for about 1 or 2 minutes with the check engine light on then all of a sudden it clears up and runs good and the light goes off. This happens once in a...
I am not sure what you are talking about with the open and closed loop but I do know that it does it on cold start and on warm start but not always on either. And I do need to get a code reader on it thats for sure.