Recent content by 94blu1500

New Member from Raleigh, NC 1998 Silverado

Welcome from Edenton, NC. Clean truck you've got there Sent from my SCH-I545 using Tapatalk
- 94blu1500
- Post #3
- Dec 15, 2015
- Forum: Introduction
94blu1500's LS Swap

I cannot remember off the top of my head. Sent from my SCH-I545 using Tapatalk
- 94blu1500
- Post #12
- Jun 18, 2015
- Forum: LSX + Carb Swaps
94blu1500's LS Swap

For the temperature gauge Green95Hoe's thread really came in handy I used the three prong temperature gauge sending unit and the old plug from the tbi throttle position sensor. Sent from my SCH-I545 using Tapatalk
- 94blu1500
- Post #10
- Jun 14, 2015
- Forum: LSX + Carb Swaps
94blu1500's LS Swap

Sorry for the late reply. The harness is a little intimidating but I done it piece by piece never taking too much of the harness apart at one time and it turned out pretty good. The gauges in my 94 are actually separate from the ecm so I found the wires at there respective sending units and...
- 94blu1500
- Post #9
- Jun 14, 2015
- Forum: LSX + Carb Swaps
94blu1500's LS Swap

Lt1swap.com has step by step directions to make the stock harness stand alone. I removed the rear O2 sensors, the evaporative emissions valve, and a couple other things that I didn't want to use. Sent from my iPhone using Tapatalk
- 94blu1500
- Post #7
- May 3, 2015
- Forum: LSX + Carb Swaps
94blu1500's LS Swap

I used the 02 ecm Sent from my iPhone using Tapatalk
- 94blu1500
- Post #6
- May 3, 2015
- Forum: LSX + Carb Swaps
94blu1500's LS Swap

So here it is: One week before Christmas of 2013 I managed to basically destroy my transmission in my truck, I knew it was coming but I still tried to do that burn out and the trans let loose :dancingpoop::dancingpoop:. i had terrible slipping between first and second making the truck almost...
- 94blu1500
- Thread
- Apr 26, 2015
- Replies: 11
- Forum: LSX + Carb Swaps
Daily truck pics

Went mudding the other day, cleaning all the crap from underneath almost makes me wish I hadn't
- 94blu1500
- Post #106
- Dec 21, 2014
- Forum: Car / Truck Photos and Videos
Carnage and Stuck Pics

Went and slung a little mud yesterday afternoon.
- 94blu1500
- Post #329
- Nov 27, 2014
- Forum: Offroad Chat / Trail Ride Reports / Carnage
What's the recommended plug wires

Went through three sets of Napa wires before I got smart and got Taylor 8mm wires.
- 94blu1500
- Post #13
- Nov 25, 2014
- Forum: Engine Performance + Maintenance
Braided stainless lines

My bad I've got a 94 k1500. but it looks like that's what your lines are for
- 94blu1500
- Post #27
- Oct 11, 2014
- Forum: Axles + Brakes
Braided stainless lines

Here is a picture of mine. The end of the brake line that attaches to the truck is in a very different place than mine
- 94blu1500
- Post #24
- Oct 11, 2014
- Forum: Axles + Brakes
Which is better a aal or 3/4 ton leaf springs?

Another vote for 3/4 ton springs. didn't change the ride much at all, and gained about 2 inches of lift
- 94blu1500
- Post #11
- Aug 27, 2014
- Forum: Stock Suspension + Bolt On Kits
replacing battery cables

I'm thinking this is right. The other wire on the starter would be the wire from the ignition switch
- 94blu1500
- Post #7
- Aug 27, 2014
- Forum: Engine Performance + Maintenance
door hinge bushings...

OEM bushings and pins are a lot better than you can get from Napa or other parts places. But if your in a pinch most parts places carry them
- 94blu1500
- Post #3
- Jul 13, 2014
- Forum: Paint / Body / Detailing