CodyDaGoat
Newbie
Blowing speeds 1, 2, and 4 work. The third one doesn’t. What do I need to look for and how do I fix it
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
mine did that. it was the switch. the true cause was the motor getting stiff from lack of lube. on the third setting it was drawing to much current through the switch and it melted the housing untill the contact couldn't make contact. .... I had changed the resistor thinking it was causing my lack of setting number 3 before. its a ****** time and it didn't fix my problem so i left in the new aftermarket resistor. this week i had to put my original one back in. i notice the aftermarket unit had a fuse rated for like 162c but the factory unit was good for 183!
I had done the resistor the same day before seeing this thread. Didn’t work. Will be trying a switch replacement in a week or twoThat makes a lot of sense . OP . I hereby withdraw my recommendation to change the resistor... you might need to change the motor ! Good luck and please post what you come up with as an answer to this.
I had done the resistor the same day before seeing this thread. Didn’t work. Will be trying a switch replacement in a week or two