Cheezebandit
I'm Awesome
My cats were going to conflict with my factory crossmember, so I built my own dropped crossmember out of some leftover 1.75" .120" wall rollcage tubing, some 2"x3" .080" wall square tubing, some angle iron, and some 1/8" flat stock.
If I were to do it over again, I'd get some more mandrel bends and raise the exhaust. The dropped crossmember is a little bit of a pain to work around.
You must be registered for see images attach
Thank you for sharing.
I definitely don't need a dropped crossmember, just something not as wide as the factory piece. I looked at the elevated concepts frame stiffener with the built in trans mount, I just don't think it will work with the QA1 torque arm brace/mount.
Dirty dingo may work. Building something may be a better option. we'll see in the future.