Late reply, I know. But if it wasn't too obvious, it is easy enough to take each section out of the set of three, the only thing that can't be changed is the blank spots. There is a model ive seen kicking around thingiverse with 3 empty spots that could be 3d printed.I've got at least one extra vertical three-hole bezel for the switches.
Find me a horizontal fog switch and I'll trade it straight across and might even throw in a couple of the easier to find switches for you.
This is what I had two months ago, and I've added at least one more triple vertical and a few other switches to it since then.
You must be registered for see images attach