Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Rear main seal isn't pressurized, this leak ran the pan dry in a hurry. So there are galley plugs at the back of the block?
Oil pressure sensor is on top, right? Top and middle of the bellhousing looked clean.
Well ****, your thread describes me to a T. Has yours blown out again since replacing it? I'm guessing blowby pushed mine out? Sure would hate to put in a new seal and not get to the root of the problem.
Mine was from a bad backfire. Read the first part of the thread I linked.
Did you ever figure the oil leak out?
Gonna do the rear main this weekend. I remembered that the LS motors will do this under boost as well which is reassuring. Their fix is better crank ventilation so hopefully it stays fixed after this.
Gonna do the rear main this weekend. I remembered that the LS motors will do this under boost as well which is reassuring. Their fix is better crank ventilation so hopefully it stays fixed after this.