Search results

  1. Jksconny

    If you wanted to show someone a picture. How do you go about it?

    It won’t let me click image button, is that because I’m a newbie?
  2. Jksconny

    If you wanted to show someone a picture. How do you go about it?

    If you wanted to show someone a picture how do you go about it?
  3. Jksconny

    5.3 clean dirty oil

    Never mind, I seen it
  4. Jksconny

    5.3 clean dirty oil

    I heard that the good old boys would shoot some diesel down in there and that cleaned it up good
  5. Jksconny

    5.3 clean dirty oil

    Yeah, I like to have things clean and proper but have ruined things trying to give it what I thought was (good medicine). I ruined a transmission that had some pretty dark old tranny fluid even though it shifted well buy changing filter and pumping new tranny fluid in while running it to get rid...
  6. Jksconny

    5.3 clean dirty oil

    I heard that amsoil use in some Honda cycle engines would also allow cylinder scoring because the tolerances were to tight if that makes sense. However I run amsoil in all my two stroke engines 50/1 no matter if chainsaw or boat motor to weed whip. Never will use anything else one and done
  7. Jksconny

    5.3 clean dirty oil

    Next question, how do you do an oil analysis? And with this truck as it being a complete 5.3 ls is that going save me a lot of money doing the swap into my 91 k2500, or is still going to be around $1500 to $2000 for swap?
  8. Jksconny

    5.3 clean dirty oil

    How long of a idle with 4 qt atf?
  9. Jksconny

    5.3 clean dirty oil

    I’m liking that idea
  10. Jksconny

    5.3 clean dirty oil

    I’m assuming it was synthetic, hoping it was but have no way of really knowing
  11. Jksconny

    5.3 clean dirty oil

    Thanks for all the feed back. I religiously change oil on or before milage and always use wix filters on my own vehicles. I was raised that oil is the lifeblood of an engine. So to sum things up change oil/ filter run a couple short oil/filter change intervals? Other than throwing a quart of atf...
  12. Jksconny

    5.3 clean dirty oil

    I had just acquired a 2000 5.3 that was rebuilt 60k ago. I also have been told the truck has been run the last two summers without an oil change and uses a little bit of oil. The engine does run good. The question I have is what would be the best way to get all of the old oil out and ensure a...
  13. Jksconny

    Soft codes 13 and 54 together needing help

    Yeah, it’s a 91 5.7 tbi
  14. Jksconny

    Soft codes 13 and 54 together needing help

    When truck is warmed up cruising down the road cel light comes on and stay on for a little bit then shut off. It does this every time I take it out. The codes are 13-o2 sensor open circut and code 54-fuel pump circuit low voltage. What I’ve done to check 02 sensor with ign on engine off .3 volts...
  15. Jksconny

    My first nv3500 swap

    I would check on the clutch pedal mount to cab/firewall, having the same provisions on the 98 to accept it. Just something to consider
  16. Jksconny

    Cab swap or powertrain

    Thank you that is the way I’m heading unless I get enough feedback to go other way
  17. Jksconny

    Cab swap or powertrain

    I have two trucks both 4wd ones an 88 1/2 ton ext cab 100% rust free. The other a 91 3/4 ton ext cab 90% rust free. Boxes of both trucks are clean and have been taken off already. Both trucks have the exact same color scheme. The 88 as I mentioned is a 1/2 ton that has a nv3500 scabbed in but...
  18. Jksconny

    Hesitation completey at a loss

    It actually started acting up a day later. I got excited for a win …….. again same stuff. But I have a solution that I will ask about on the body page. Damn I wish I didn’t love these trucks so much
  19. Jksconny

    Hesitation completey at a loss

    All the components are good after checking for 100 times. I did not change anything, started acting up again a day later.
Top