Right, I understand that. Shipping the arm rests and map pockets should not be a problem though. I will happily pay for them if you decide to take them off the door panels. Do not need the entire door panel.
I know you said your are saving the door panels for local sale, but is there any chance I can buy the arm rests and the map pockets off of them and have them shipped?
I am looking for a fan w/ clutch and full shroud if you still have it. Also, if you have manual windows, I am looking for the map pockets on the bottom of the door panels. Give me a price shipped to 79106. Thanks.
Dr. Chop, I was not trying to argue with you... I have said numerous times I am not set on a particular diameter... I made the post to see what wheels everyone else who has done this drop have ran, regardless of diameter. I have done a ton of research on this the drop, the only area I am...
Im sure he says it is. He said it is is spindles, 3" spring minus a full coil, which is 2"... unless he lied. Although I have seen a million 6" drops and they look close to that.
Sent from my SCH-I605 using Tapatalk 4
Thanks *****!
I am not hard set on 20s, I would just prefer that and I have seen it done before on a DD. If anyone has any experience with the drop, I would like to hear your wheel/tire specs for any diameter.
There is a truck at 4/6 or 5/8 in Canyon with them or something very similar and it looks awesome. But from what I have read you would have to have a tiny tire and limited turning at that low of a drop... *****, what offset/backspacing are your wheels?
Sent from my SCH-I605 using Tapatalk 4
I have seen the sticky, but don't think it is good for a 7/10 drop. What specs would be ideal to tuck tire? I can roll fender lips and remove liners on the front, back needs to tuck into a step side... so what are you hardcore staticers running??
Sent from my SCH-I605 using Tapatalk 4