Recent content by Smitha

  1. S

    94 temperature gauge issue

    Ok guys. Put a new different temp sender in and that was the problem. Only thing is it only goes up to the 1/4 mark. I guess its better than reading max hot Sent from my SM-A205U using Tapatalk
  2. S

    94 temperature gauge issue

    Lmao! not a clue why I said block. But yes that's the one. Sent from my SM-A205U using Tapatalk
  3. S

    94 temperature gauge issue

    It somehow went right over my head that yours was vortec when I saw it from the sensor. If not air in the line and all wires are good it could be a faulty new sensor. Thanks again Sent from my SM-A205U using Tapatalk
  4. S

    94 temperature gauge issue

    No it's the one on the block. One wire. Had the horizontal and vertical pin. It looked exactly like the old one. Sent from my SM-A205U using Tapatalk
  5. S

    94 temperature gauge issue

    got it from rock auto.. WVE 1T1048
  6. S

    94 temperature gauge issue

    Haha! True. So how do i verify i have the right part? One is a sensor and one is a sender and i made sure it was a sender.
  7. S

    94 temperature gauge issue

    Im just not sure how it would be the wrong part used since the connector clip is different from the sensors but i will check it. Thank you for everything else you have mentioned and others. Appreciate the help!
  8. S

    94 temperature gauge issue

    Thank you! Not sure how it could be the wrong sender since it plugged right in but i will double check.. From reading the link almost make me think its got air in the system.
  9. S

    94 temperature gauge issue

    i know its a sending unit just cause the connections are different. I will check for bare wires. Thanks!
  10. S

    94 temperature gauge issue

    If this is already posted i apologize. i just couldnt find it. i have 94 v6. The temp gauge was hardly going above 100 on road trip. Replaced thermostat and it went to about 1/4 mark. Just replaced both sensors and now gauge goes to complete max hot after about a minute. Engine runs fine and not...
Top