Recent content by Noah1167
-
1995 Tbi 350. Runs for 30 seconds then dies. Feels rough.
I have read about all of these. For oil pressure i wasn't sure but have heard about it being off the oil pressure sensor. So i replaced the old one and shot the wires to make sure that it was getting what the schematic was showing. Checked all good. For the fuel pressure the truck has an...- Noah1167
- Post #19
- Forum: Engine Performance + Maintenance
-
1995 Tbi 350. Runs for 30 seconds then dies. Feels rough.
How about cap, rotor, plug wires, spark plugs, PCV valve? Have you verified the initial timing, electronic spark advance: I have replaced the entire ignition system. New plugs, new wires, new distributor. New ignition coil. new pcv. new egr. new egr solenoid. I had a tech at a local shop...- Noah1167
- Post #11
- Forum: Engine Performance + Maintenance
-
1995 Tbi 350. Runs for 30 seconds then dies. Feels rough.
Thank you for your reply. I just checked the sensor using the chart you provided. Sensor read with in spec. Tested two other sensors that i had previously and relayed the data at different temperatures and those also pass. now for the seconds step that you posted. Im having a difficult time...- Noah1167
- Post #10
- Forum: Engine Performance + Maintenance
-
1995 Tbi 350. Runs for 30 seconds then dies. Feels rough.
I did all the work. The truck was bought over a year ago. Ran horribly due to a bolt logged in a valve seat. Fun times. Two new replacement heads. In that time. Bought every sensor. Fuel injectors also. All from autozone. Most of these duralast brand and fuel injectors not sure. For grounds...- Noah1167
- Post #4
- Forum: Engine Performance + Maintenance
-
1995 Tbi 350. Runs for 30 seconds then dies. Feels rough.
Alright let me get to the point. Every sensor on the engine has been replaced. Fuel injectors replaced. Fuel pump. consistent 13psi from pump to TBI. Took every ground out and cleaned and replaced. Replaced wiring pigtails for any connector that looks rough/broken or had corrosion in pins. Now i...- Noah1167
- Thread
- engine performance
- Replies: 19
- Forum: Engine Performance + Maintenance
-
95 350tbi won’t run right!
Alright thank you guys for your responses. I did end up connecting a scan tool and found out that i wasnt getting readings for the tps and for the coolant temp switch at the front of the intake manifold. Did some extensive wiring and replaced every ground. Fixed the issue and ran correctly.- Noah1167
- Post #6
- Forum: Engine Performance + Maintenance
-
95 350tbi won’t run right!
I will double check it. It was a brand new part. The old one was stuck shut.- Noah1167
- Post #3
- Forum: Engine Performance + Maintenance
-
95 350tbi won’t run right!
Alright let’s see how this goes. Got the truck. Didn’t run well. Figured out that everything was pretty shot and needed to be replaced. Replaced every single sensor for engine performance. Rebuilt the throttle body ( brand new injectors ). Cleaned fuel lines and fuel tank. Changed spark plugs...- Noah1167
- Thread
- dumb running rich running rough
- Replies: 6
- Forum: Engine Performance + Maintenance
