A few years back I had removed the bed and I had the bottom of the bed blasted as well as the frame. I then painted both. This time I couldn't blast it so I sanded it the best I could and then painted with por-15
build
The work continues but it's been slow. I'm trying to detail everything as muc as possib;e. I actually tumbled all the bolts and then had them re black oxide coated.
I had it running but it had an overheating issue. I installed a GM goodwrench stock 350. It was quick with the turboes but the stock headgaskets and bolts were allowing boost to get into the radiator. I decided ARP bolts and Dart heads. I figured if I have it apart I may as well change the...
I need the right side that has the actuator in it. The flange that connects to the CV joint was coming in and out too easily. I took it off and was messing around with the small gear and put it on backwards and it got stuck. The locking clip apparently held it in that position. I tried to...
I need the right side that has the actuator in it. The flange that connects to the CV joint was coming in and out too easily. I took it off and was messing around with the small gear and put it on backwards and it got stuck. The locking clip apparently held it in that position. I tried to...
that has the actuator in it. The flange that connects to the CV joint was coming in and out too easily. I took it off and was messing around with the small gear and put it on backwards and it got stuck. The locking clip apparently held it in that position. I tried to pull it with a puller...
My old ones were never coming out. So they were plasma cut out. The new ones rest on the flats but before they do there is a little twist. I guess it should be fine though. I'm not sure where to put the key though. Since I cut them out i don't know how far it sticks out before you twist it...
So I went to install my new torsion rods. They have a fair amount of slop in the a-arms. Is this nl? I figure when they are loaded it will be gone but I wanted to see what other people have. My first rods had to be cut out of the truck so I didn't know what type of slop they had