Recent content by miroslav
-
T56 Magnum Gear Ratios
Nice clean truck! I wish mine was that clean. I get it, I started collecting parts for my swap a while ago. Still have not gotten the trans yet, though... I decided to do an EFI Connection 24X swap on my original small block, along with the manual trans swap. Please keep us updated on your...- miroslav
- Post #6
- Forum: Transmissions
-
T56 Magnum Gear Ratios
Did you ever complete this swap? I am starting this same conversion with my 97 and was also looking at the TUET16885. How do you like it?- miroslav
- Post #4
- Forum: Transmissions
-
-
Mechanical height control valves?
Guys, my AccuAir system is starting to act up, giving me sensor failure faults. I have not been able to find replacement sensors since they went out of business, and don’t want to spend $2k on a new ride tech e5 system. Has anyone ever tried to set up an light duty air suspension using...- miroslav
- Thread
- Replies: 0
- Forum: Lowered and Bagged Suspension
-
Lowering leaf springs
I ran a 3/4 static drop long time ago before I bagged mine. I had 2” spindles and 1” springs up front and Hotchkiss 4” leafs in the back. Hotchkiss no longer makes those springs though. I liked the look with the 3/4 drop but the ride was pretty stiff. My biggest complaint was that I couldn’t...- miroslav
- Post #3
- Forum: Lowered and Bagged Suspension
-
-
97 5.7L Vortec: can I delete the post-cat OXYGEN SENSORS without much headache? (non-emissions test)
They were the ones made by Casper's Electronics and sold through Summit Racing back in the day. I'm pretty sure they are discontinued now because I can't find any info on them anywhere. They were nice back in the day because they had the factory style connector on them and they were epoxy...- miroslav
- Post #11
- Forum: 96+ Vortec Performance + Computer Swaps
-
97 5.7L Vortec: can I delete the post-cat OXYGEN SENSORS without much headache? (non-emissions test)
I ran a pair of O2 sensor simulators for years while still having to pass an OBD2 e-check. The simulators will turn off the check engine light but the Catalyst Monitor in the ECM will just stay in Not Ready mode because they only see a flat response from the simulators. It was a pain in the...- miroslav
- Post #9
- Forum: 96+ Vortec Performance + Computer Swaps
-
Whyyyyyyy
Nothing a few cans of Krylon can't fix...- miroslav
- Post #10
- Forum: Ebay / Craigslist Finds
-
A pillar Gauge pods
- miroslav
- Post #8
- Forum: Audio + Electronics
-
A pillar Gauge pods
I have a triple gauge setup also. All Auto Meter 2-1/16" gauges. Trans Temp, Air/Fuel Ratio, and Air Pressure for my air ride suspension. I don't think you will find a quad setup anywhere. The triple already goes all the way up the windshield. I also painting it to match the factory...- miroslav
- Post #6
- Forum: Audio + Electronics
-
New member from Cleveland, Ohio
Thanks guys. Here are my trucks:- miroslav
- Post #6
- Forum: Introduction
-
New member from Cleveland, Ohio
Hey everyone, I am a new guy here from Cleveland, Ohio. I love these GMT400 trucks so much, I have two of them. A 1997 C1500 ECSB 2wd pickup truck that is my toy, and a 1999 4 door 4wd Tahoe that is my daily driver. I'll try to get some pictures up eventually...- miroslav
- Thread
- Replies: 7
- Forum: Introduction
