Recent content by Matts88
-
M
Tbi 350 bogs and stalls at half throttle
Oh alright, sounds good man thank you. I've currently got a decent obd2 scanner, I'm going to attempt to just throw an adapter on it but if that doesn't work I'll be ordering one of the snap on ones.- Matts88
- Post #13
- Forum: Engine Performance + Maintenance
-
M
Tbi 350 bogs and stalls at half throttle
I had the paper clip slid into the middle terminal on the sensor, connected the positive meter lead on the paper clip, and the negative on a clean spot of the throttle body. What kind of scan tool? I didn't know they had one for obd1- Matts88
- Post #11
- Forum: Engine Performance + Maintenance
-
M
Tbi 350 bogs and stalls at half throttle
No vacuum 4.77v, 5psi 4.98, 10 psi 4.98 again.so that means the wiring is bad?- Matts88
- Post #9
- Forum: Engine Performance + Maintenance
-
M
Tbi 350 bogs and stalls at half throttle
I couldn't find the adapters for the fuel lines anywhere in town, neither the in line one or the one behind the throttle body. I attempted to shove the rubber hose over the nozzles but it didn't hold enough to read the pressure. I found some that look like they'll work on Amazon so I'll order...- Matts88
- Post #8
- Forum: Engine Performance + Maintenance
-
M
Tbi 350 bogs and stalls at half throttle
it reads 4.98 volts on the multimeter set on dc, with the negative in the middle and the positive on the hot terminal. I'm not sure what you meant with the paper clip though?- Matts88
- Post #3
- Forum: Engine Performance + Maintenance
-
M
Tbi 350 bogs and stalls at half throttle
I have a 1988 Chevy suburban with the 350 tbi in it. I had a problem where it idled fine, revved up good in park/neutral, but when you put it into gear and give it more then the slightest bit of gas is would bog down and stall out. I have since replaced the vacuum lines and checked the Egr. Egr...- Matts88
- Thread
- Replies: 17
- Forum: Engine Performance + Maintenance
