Recent content by FrumRoll
-
F
New from Minnesota
It'll be returned to stockish, bench seat, rubber floor. I just have it torn apart to clean up the wiring and modify the HVAC. I'd really like to delete the A/C and the vents properly. Check here if you have any thoughts? Thanks, everyone has been very welcoming.- FrumRoll
- Post #12
- Forum: Introduction
-
F
New to here but like what I see.
Welcome from Minnesota, I'm new hear myself. I'm also excited to see an active forum, first I've signed up for in a while.- FrumRoll
- Post #11
- Forum: Introduction
-
F
New from Minnesota
Yeah, the gears don't last real long but I do run it up to 7k so that helps some. Also don't put a lot of miles on it so that helps as well just have to cruise under the speed limit when on the freeway. I've got a KP 4-Link setup that should solve it as well, I just haven't been able to get a...- FrumRoll
- Post #8
- Forum: Introduction
-
F
New from Minnesota
Thanks, I'm pretty happy with it. Still need to finish my wiring project, install the electric water pump and route the spark plug wires properly. I'd also like to get a serpentine belt at some point.- FrumRoll
- Post #6
- Forum: Introduction
-
F
New from Minnesota
Just joined from Minnesota, excited to find what seems like an active board for the OBS trucks. I've got myself an '89 GMC 1500 RCSB W/T. I've had it for 7 or 8 years, was mostly built when I bought it. Had already had the motor pulled replaced with a 355 and carb'ed, the usual heads\cam\intake...- FrumRoll
- Thread
- Replies: 13
- Forum: Introduction
-
F
Looking for Non A/C Parts
Hello, Was looking for some help, ideally I would like to replace the A/C with Vents in my '89 for a Non A/C without Vents setup. I'm looking to do this as close to factory as possible, anybody have experience with the Non Vent setups? Do they use the same Air Distributor setup, if so what...- FrumRoll
- Thread
- Replies: 0
- Forum: OEM and Custom Interiors
