The phone camera exaggerates the issue a little, but it is definitely very bright right in front of the truck. I aimed mine on a wall at 25' away, using some tape marks to mark the centerline of the truck and each light, and a horizontal line at the height of the lights. I think I have the...
Thought I'd post some photos of the actually light output from these after re-wiring the headlights with larger gauge wire, relays, and "4-hi". I adjusted them based on Daniel Stern's instructions on his site, but I think they are aimed just a tad low. The low beams have a pretty sharp cut-off...
I got the wiring done today and everything buttoned back up. I ended up disassembling the Arteb headlights yesterday to lube the adjusters, and put in the new bulbs.
I used 3 relays. One powers Low, one powers High, and the third enables 4-Hi by triggering the Low Beam relay when the High beams...
The "kit" I got is really just the parts kit, it is for DIY. I've not worked out exactly how I am going to wire it all up yet. I actually have 3 relays, 2 for powering low and high beam respectively, and one more to configure "4-high". I've been looking at wiring diagrams and trying to...
I need to go back and check the adjuster lube situation on mine, I did not do that. I also have not tried to aim them yet. I basically just bolted them on with the original bulbs and harness to see how they fit and look.
I'm trying to figure out how to make the 'city lights' my DRLs, without...