Veeman's 97 build

[95C1500]

There's a couple of write ups in the toewing section on how to wire in a brake controller if you're going that route.

 

[Veeman]

No I don't need electronic brakes I'm only going to be towing a small trailer and my jetski. I just didn't know what those two extra wires were for.


Sent from my iPhone 5 using Tapatalk

 

[Veeman]

Well pretty much done the rear just got to replace the drums and get the wishbone,tanks and trailing arms powder coated. Then on to the front end next!

You must be registered for see images attach

Sent from my iPhone 5 using Tapatalk

 

[smurfcivic]

Looks damn good. Now I gotta paint my gas tank thanks!

 

[KReePiN]

Thats one of the cleanest ive seen in a long time


Sent from my iPhone

 

[Veeman]

Thx guys I can't wait to get my parts powder coated getting them done in a Pepsi blue color same as what I'm painting the truck.


Sent from my iPhone 5 using Tapatalk

 

[Veeman]

Brought out my little sandblaster that I haven't used in about 6 years and blasted the rims I'm gonna use.

Before

You must be registered for see images attach

After

You must be registered for see images attach

Sent from my iPhone 5 using Tapatalk

 

[98nightmare]

Drivers side notch.. bottom rear... weld the gap up bro, truck/ work is looking to good for a misshap to happen later! Keep it up bro, its looking great!

 

[Veeman]

There is no gap it's fully welded just the light in the pic mang


Sent from my iPhone 5 using Tapatalk

 

[Veeman]

98, I think I know what your talking about now it's not the c notch but right behind it right? Yes this was an old hole for the old shock mount that lost a fight with my cutting torch. I was thinking you were talking about the c notch itself. Yes I'm going to fix that it's cosmetic tho it looks closer to cnotch because my weld pass basically goes right along it.


Sent from my iPhone 5 using Tapatalk