GonzalezKustomzFab
OBS Enthusiast
- Joined
- Jul 4, 2012
- Messages
- 52
- Reaction score
- 8
Ok I thought I would share this I seen these on the web for as much as 50 bucks that's some bs so I thought I would build my own took me a total of 15min he's a step by step to make your own sheet metal panel holders
1) your going to need some 1"x1" sq tubing the thickness don't really matter I had some .095 laying around so I used it
2) 1/4" round stock , and a pc of some 18g sheet metal .. You could use whatever thickness you want
3)your going to need some 1/4" x 1-1/4" flat head machine screws and wing nuts
4) tools you will need 4.5" angle grinder with a cutting wheel
Center punch, file , drill or drill press with 1/4" bit and some needle nose vise grips
5) cut the sq down the center , clean it up with the file , drill a hole on the top ,insert your flat head machine screw, cut your 18g to size drill a hole on the 18g as seen in the pic , insert your 1/4" round and your down
1) your going to need some 1"x1" sq tubing the thickness don't really matter I had some .095 laying around so I used it
2) 1/4" round stock , and a pc of some 18g sheet metal .. You could use whatever thickness you want
3)your going to need some 1/4" x 1-1/4" flat head machine screws and wing nuts
4) tools you will need 4.5" angle grinder with a cutting wheel
Center punch, file , drill or drill press with 1/4" bit and some needle nose vise grips
5) cut the sq down the center , clean it up with the file , drill a hole on the top ,insert your flat head machine screw, cut your 18g to size drill a hole on the 18g as seen in the pic , insert your 1/4" round and your down
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach