Big RED Burban
OBS Enthusiast
i know this is probably a dumb question but i need an answer i had to take my centerlink and tie rods out so i would have room for sone internal engine work and now im in the process of putting it back together and when i try to thighten the ideler arm(where it connects to the frame mount) and outer tierod ends (where they connect to the spindle) with the impact the nuts go down about half way then they grab and the studs start spinning i know they are worn out but is there anyway i can get them tight does it have to be on the ground maybe? i know i should replace them but i need it on the road now is there anyway to stop them from spinning so i can thighted them enough to drive it any help you can give would be appreciated
thank you
thank you