98_k1500
strange noises are normal
Over Christmas, my girlfriend's car motor took a dump (timing belt broke on her kia, destroyed the whole engine). I bought a 94 1/2 ton long bed i knew where was for $400. It had a nv4500 trans, and a blown up 4.3 v6. Had a new pair of heads with it, and i had a low mile 4.3 with a cracked head laying in the shop. Old truck has 362,000 on the clock, and the speedo/odo does not work. Pulled the motor down (been sitting several years) rings were stuck. Cleaned the pistons up, and a gasket set later i had a running truck she can use til she gets something else, then i plan to make some money on it. I plugged to it with a old snap-on OBD1 scanner i have access to and the computer is not seeing a speed signal. The speed sensor looks new, someone has definately had it out and cleaned it up anyway, so i figue throwing parts at it is not going to fix it. Being a 94 with a manual trans, this truck has a DRAC module. It seems to only have 1 plug plugged into it. Images i have found online have a 2nd smaller plug plugged into it. Am i missing some wiring? Or does a 94 only use 1 plug on it? Any help would be greatly appreciated because she really could use a speedo and thats the only thing in the whole truck that don't work.
The small plug on the left (yellow wire) is not present.
This one has a red wire in the left plug.
You must be registered for see images
The small plug on the left (yellow wire) is not present.
You must be registered for see images
This one has a red wire in the left plug.