Michael Cook
Newbie
1995 K2500 Silverado 2 door, extended cab 5.7L, Auto, Long bed
All my lights work except brake lights...tail, turn,back up. 4 way
I have changed all parts related except for the wires.
fuse(under hood 30 amp), relay, switch(2x) turn signal arm, 3rd brake light, circuit boards in the rear.
I have disconnected all non OEM wires, ie 5 pin trailer connector and brake controller.
I have test light the orange wire at the brake light switch and it is hot.
I have jumped wired the orange and white wire at the plug at the switch and all brake lights come on.
I have installed the switch and activated it with a screw driver and all brake lights come on.
I have plugged the switch in and installed the switch by placing it on the pin at the top of the brake pedal and clicking it down onto the pushrod.
step on the pedal...no brake lights, started the truck and pressed the pedal, no brake lights.
I did not put the clip back on the rod to hold the switch because its a pain in the $%^. So I held it tight and pushed the pedal...nothing. Put a NEW clip back on and still nothing
Bought a second switch just to confirm the new one wasn't bad(it happens, I know)...nothing.
I don't know what to do from here.
Any ideas you would have would be appreciated. Thanks
All my lights work except brake lights...tail, turn,back up. 4 way
I have changed all parts related except for the wires.
fuse(under hood 30 amp), relay, switch(2x) turn signal arm, 3rd brake light, circuit boards in the rear.
I have disconnected all non OEM wires, ie 5 pin trailer connector and brake controller.
I have test light the orange wire at the brake light switch and it is hot.
I have jumped wired the orange and white wire at the plug at the switch and all brake lights come on.
I have installed the switch and activated it with a screw driver and all brake lights come on.
I have plugged the switch in and installed the switch by placing it on the pin at the top of the brake pedal and clicking it down onto the pushrod.
step on the pedal...no brake lights, started the truck and pressed the pedal, no brake lights.
I did not put the clip back on the rod to hold the switch because its a pain in the $%^. So I held it tight and pushed the pedal...nothing. Put a NEW clip back on and still nothing
Bought a second switch just to confirm the new one wasn't bad(it happens, I know)...nothing.
I don't know what to do from here.
Any ideas you would have would be appreciated. Thanks