I bought the complete SS Dorman kit off Amazon Warehouse for like $25.00. I’ve installed all the rear lines so far, all perfect fit and zero install issues.Take a look at Rock Auto for pre-bent SS kits. I am replacing the flex lines with braided no-flex lines during a hydroboost swap and when I removed the rear flex line the tubing twisted off with the flare nut on the drivers side axle and the main feed line. Picked up a Dorman kit from Rock Auto for $140 to the door. I haven't installed it yet since it just happened last weekend and the kit came yesterday but I did inspect and test fit and the kit is complete and accurate to the truck. I'm only going to replace the lines under the bed because they're the ones that see road spray (also two of the four pieces are presently busted which is why I'm doing it at all). The remainder of the kit I'll keep for as needed repairs going forward. From what I've read on sealing you just need to put the nuts through a few tightening/loosening cycles to get a good seal on SST.
1998 Z71 5.7L.
I agree on Inline Tube post. Would’ve gone with them had I not scored my kit.
Last edited: