here's the deal, i'm swapping an LS1 into my truck. i sold my old motor with the harness then realized i still need part of the harness for some things, a/c, fuse center, firewall plug, etc...
i bought a harness from pull a part but the engine was already pulled so i couldn't label what the plugs went to.
i know most of this i will not use but i would like to make sure i don't remove anything i'll need & would like to know what the plugs are for in case anyone ever needs them.
on to the pics. i tried to take them in order from the firewall plug to the trans.
You must be registered for see images attach
pretty sure these went to the throttle body, TPS, IAC but not sure what the other plug & cut wires go to around there.
You must be registered for see images attach
next up the harness. i think the one with the tape on it is for the temp sensor
You must be registered for see images attach
the one's tied together, blue & purple i think are for the starter, once again i'm not sure what the others are for.
You must be registered for see images attach
pretty sure these are for the a/c & heat & maybe one for the squirters?
You must be registered for see images attach
this group is right before the trans plugs.
You must be registered for see images attach
& obviously the trans plugs.
You must be registered for see images attach
if anyone can help identify any of these that would be great. i know there's the o2 sensors (should be 4), MAP, MAF, air temp, crank, knock, etc.. just not sure what is what.