Alrighty! I got some pictures. I have received my inner rocker/outer floor panel, the full rocker panel and the floor panel. So today I had some time so decided I would tackle the driver side
I manange to fit in the rocker panel first, figured if I would work my way in, Yes, it is backwards but it seem to make sense... So I fit the rocker panel on, then I cut the inner rocker to fit the new one. The new one came with welded in nuts for the seat belt on the seat, but figured I didn't need that so I cut that off. Once that was in I took it off and drilled the spot welds for the floor panel so I can get the new piece in. This piece, I thought was going to be a night mare, let me tell you! It couldn't have went any smoother!!
Heres crappy Cell pictures, I lost my camera charger so I used that...
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
so for now, I still need the inner cab corner and abit of sheet metal to repair the front of the cab (right behind where the fender bolts in to the cab. then ill be ready to fit the cab corner on and weld everything in place! I figure another few hours and ill have everything ready to weld. Then a good hour to prep the metal and weld it in place. Im hoping to do the back of the cab seams so I can shave it and have a clean look.