Recent content by wally
-
Panel Alignment
Pins would be my first step as long as the hinge it’s self are not wore out- wally
- Post #2
- Forum: Paint / Body / Detailing
-
Procedure for minor surface rust?
Just my 2 ct but you can also use white vinger to remove surface rust. I had some typical rust on the roof ,took a gallon of white vinger added a cup of salt mixed it together and laid paper towels over the rust spots and poured the mixture on and let it soak. A couple hours and then scub it off...- wally
- Post #13
- Forum: Paint / Body / Detailing
-
A tailgate lock+cable replacement (92 CK truck)
Man that's cool I was thinking the old plastic bezel with the lock in it from back in the day- wally
- Post #10
- Forum: Paint / Body / Detailing
-
96 rear gate rebuild questions
It's a cake walk. Rebuilt mine took about 15 minutes . I replaced the latch assembly at the ends of the gate- wally
- Post #4
- Forum: Paint / Body / Detailing
-
ideas, please help
I have to agree With the 95 sport mirrors . They look good and you can see ok out of them. I also like the cowl hood . Imo these trucks look better with it but I'm partial to them because I have one- wally
- Post #12
- Forum: Paint / Body / Detailing
-
Tailgate adjustment
I took my tailgate off to rebuild it and flip the handle inside the bed it's got 233 thousand on it and noticed the top is not as flush as I like"ocd" ,but it I does not rattle like it did either- wally
- Post #7
- Forum: Paint / Body / Detailing
-
Tailgate adjustment
Thanks for the input guys . It's pretty bad I own the service manuals and nowhere in them does it give an adjustment procedure for it . Thanks again- wally
- Post #4
- Forum: Paint / Body / Detailing
-
Tailgate adjustment
Is there a away to adjust the striker on either the tail gate or the bed?- wally
- Thread
- Replies: 7
- Forum: Paint / Body / Detailing
-
So.... I blew my muffler up
Just my 2ct. But my truck 95 had a rough like yours went through 2 cats replaced ignition parts and o 2 sensor and a rich smell at idle from exhaust tried everything . Got to the point of rebuilding the throttle body and the o rings that the injectors sit in at the bottom had a flat spot in it...- wally
- Post #17
- Forum: Engine Performance + Maintenance
-
Recommendations on Seat Covers
I used coveking neoprene seat covers as said above they take a while to get and there not cheap 230.00 but well worth the money- wally
- Post #6
- Forum: OEM and Custom Interiors
-
Glass Lense Headlights
And I purchased them not that long ago not even a year ago- wally
- Post #11
- Forum: Paint / Body / Detailing
-
Glass Lense Headlights
Ihad a set in the past once and that's exactly what happened picked up a rock chip cracked one of the lenses. I bought them at all GM nationals in Carlisle . They lasted quite a while for years Before it happened . I recently bought a set of glass chrome ones on auto-parts warehouse I believe...- wally
- Post #10
- Forum: Paint / Body / Detailing
-
Tail light issues
Could be the circuit boards at tail lights they are a pia- wally
- Post #2
- Forum: Audio + Electronics
-
Camper Mirror Replacement
To be honest I don't have a clue. Sorry I can't help you there.- wally
- Post #6
- Forum: Paint / Body / Detailing
-
Camper Mirror Replacement
Best thing to do is break out the welder and fill the holes. IMHO that's what I would do to my pride and joy:)- wally
- Post #3
- Forum: Paint / Body / Detailing
