okay will check valve seals first but also still have the question about the block for the coolant port on the intake manifold gaskets are they supposed to both be in the back or are they supposed to be offset
it did not smoke on the initial startup and first drive it did not start smoking until we tighten down the valve covers and I didn't notice it until we were driving
Ok just put two reman heads and all new gaskets and only ran twice. Now smoke is coming out . The intake gaskets have a block on one end and open on The other for the coolant ports. Are they supposed to be offset? Im lost as to why its smoking. Its kinda blueish so im thinking oil but why. Its...
Ok with some very careful thought and time i decided to go with.......the Mustang (sold on the test drive) glad i did it is sweet. Already have done a cai tb o/r xpipe and a flowmaster cat back. next tomorrow im dropping it off and picking it up sat afternoon it will have 4.10's installed and...
http://www.ebay.com/itm/383-STROKER-COMPLETE-SHORT-BLOCK-KIT-FULLY-MACHINED-SCAT-CRANK-FORGED-PISTONS-/350586248843?pt=Motors_Car_Truck_Parts_Accessories&hash=item51a0919e8b&vxp=m
There is also this option. becaus i can also get a set of vortec heads bare for 350 a pair.
Well i would be happy with a motor that gives me 300whp or more which im guessing its easier to get more if you have full bolt ons with long tubes. with 4.10s and higher stall i should be able to walk a stock mustang at our local track which is only 1/8th mile. then i could also throw on a 100...
Ok so today i was approved to buy a 2003 Mustang Gt. Its got 60000 miles no upgrades. This car has been well taken care of and babied all its life lol. Now the guy is holding it till sunday for me. I have a 3500 dollar budget i can either use as a down payment or if yall think i can build a...
Well i have the low end monroes on right now from oreillys.... gotta love lifetime warrantys, just go in and say i need to warranty these and upgrade and get sensatracs half off.. win for me.