stock 93 rcsb stepside k1500 4.3 tbi 226k
I am planning to replace my wheel hub bearing and cv axles next weekend and was looking for any tips/suggestions or any special tools that make the job easier. Is it best to replace both sides at the same time? It appears the cv axles are original and the passenger side is making a light grinding type noise at the inner flange when the wheel spins fwd/back in 2wd. The drivers side makes no noise. Both sides inner boots look good. The outer boot on the passenger side is torn all the way around on the small side near the clamp. The haynes manual I have shows cv axle remove/replace but nothing really regarding the wheel hub bearings. Will get on the net and look for some videos this week. Thanks in advance for any responses
I am planning to replace my wheel hub bearing and cv axles next weekend and was looking for any tips/suggestions or any special tools that make the job easier. Is it best to replace both sides at the same time? It appears the cv axles are original and the passenger side is making a light grinding type noise at the inner flange when the wheel spins fwd/back in 2wd. The drivers side makes no noise. Both sides inner boots look good. The outer boot on the passenger side is torn all the way around on the small side near the clamp. The haynes manual I have shows cv axle remove/replace but nothing really regarding the wheel hub bearings. Will get on the net and look for some videos this week. Thanks in advance for any responses