-
-
So..... I just bit the bullet, fell off the deep end, and ordered the Motion Racework shifter. I wasn't able to afford the CO2 assist... -
Reluctanse replied to the thread Bowtie Brody's Namesake 96 454.I need to do something with my exhaust, it can't stand it. And my theory of ignoring the broken manifold studs until I "do headers...
-
Reluctanse replied to the thread RPM Increases, Truck Wont Budge!.could also be a broken axle shaft if the driveline is moving but your not. something in the rear axle.
-
I got 37 cents and a stick of juicy fruit gum. Final offer. :anitoof:
-
Reluctanse replied to the thread stuff that catches my eye.Facebook marketplace, man such a hive of scum and villainy...
-
-
Congratulations to @kennythewelder (me) TOTM winner for October 2023, with 13 votes. Thank you to, everyone who voted for me.
-
Reluctanse replied to the thread 12200411 PCM swap for 1996 to 2000 GMT400 trucks.It’s test, really-how bad do you want that 0411? I had to dig into the recesses of the internet to find his email…
-
Reluctanse replied to the thread 7.4 Vortec Intake Manifold Gasket Preferred Brands?.Definitely go with the rtv on the china walls, no issues here doing that with felpros. I also used this stuff called gasoila on the...
-
Reluctanse replied to the thread My 454 Rebuild.Too bad... but sometimes you just gotta move on. I don't think a build thread for a GMT800 would be inappropriate-
-
Reluctanse replied to the thread O2 sensor connector pigtail is gack’ed… pointers on replacing it?.I think I can pull it up from the distributor area and get it from there… I guess it must get hot back there right above the manifold...
-
Reluctanse reacted to Schurkey's post in the thread O2 sensor connector pigtail is gack’ed… pointers on replacing it? with
Like.
...and add some heat-shielding. -
Reluctanse reacted to Komet's post in the thread O2 sensor connector pigtail is gack’ed… pointers on replacing it? with Like.
There's two ways to get the access you need; remove the wiring from whatever's clipping it to the vehicle until it dangles far enough...
-
Reluctanse replied to the thread O2 sensor connector pigtail is gack’ed… pointers on replacing it?.That’s what I’m saying I’m going to do, just how to actually access the wiring harness to do it is the question. I’m going to stop by...
-
Reluctanse posted the thread O2 sensor connector pigtail is gack’ed… pointers on replacing it? in Engine Performance + Maintenance.2000 k3500 l29 truck Been chasing misfires and I might have found the culprit… I went to replace the o2s and found this… Drivers side...
-
-
Reluctanse replied to the thread 12200411 PCM swap for 1996 to 2000 GMT400 trucks.What kind of issues? I had to make adjustments to the ABS tables in the speedo section in HPTuners to get the ABS light cleared, but...
-
-
Loading…
-
Loading…
