Have not done a lot with the truck since the last update. Planning on getting the engine in this summer and I need to replace the out put seal on the tranny as well!
Sent from my iPhone using Tapatalk Pro
So it's been a long while. I dont even know where to start an update. I'll just post some recent pics I guess. And yes I know the hood is horrible. I really need to paint it.
Putting together a new engine for her
Got new tire and wheels at the beginning of the year
Bought the wife a...
Ok I have a 94 k1500 and I have swapped in a 01 rear end with disc brakes. Have also done the NBs master cylinder swap. But my rear brakes will lock up before the front. So if I were to remove the rwal and the proportioning valve would that solve my problem? I have an adjustable proportion valve...
Do i need to get a chip for my 94 k1500 if i run an engine with vortec heads and an rv cam in it? And i will be keeping the tbi set up. Just going to be using a holley tbi for it
Sent from my SM-G935P using Tapatalk
I had a set of 20x12s on my truck in a negative 44 offset. And a 35x12.5 tire. With my spindle lift on the truck the tires in the front were sticking out about half way. The rears were sticking out probably 4 or 5 inches
Sent from my SM-G935P using Tapatalk
https://www.crutchfield.com/p_122555/XS-Power-555-i-BAR-Multi-top-Post-Terminal-Adapter-Kit.html?tp=36390&awkw=51781638172&awat=pla&awnw=g&awcr=47716945465&awdv=m&awug=9030890
Sent from my SM-G935P using Tapatalk
I was just wondering on the gap because ive seen some racks that sat like 6 inches off cab due to body flex but i think that was an excessive gap
Sent from my SM-G935P using Tapatalk