Recent content by James Kiger
-
J
350 vortec issue.
Let it run for about an hour while I cleaned and organized some tools. It cleared up a ton and now holds fuel pressure with no leak down. No more bogging. Poppet stuck open that resolved its self?- James Kiger
- Post #8
- Forum: Engine Performance + Maintenance
-
J
350 vortec issue.
OK so did some further testing today. Pulled a few plugs and it's definitely burning lean, fuel delivery issue. Hooked a pressure gage back up and key on pressure is 61 psi. Running psi is 50 psi which is low. Very quick leak down on the gauge, drops from key off 60 psi to 30 psi in less than 2...- James Kiger
- Post #6
- Forum: Engine Performance + Maintenance
-
J
350 vortec issue.
Tank was drained during pump replacement. It's hard to get a sumped tank completely empty, I'm sure there was a tiny amount leftover. Added 7 gallons of fresh.- James Kiger
- Post #5
- Forum: Engine Performance + Maintenance
-
J
350 vortec issue.
Will do. Before I did the intake gasket the fuel trims were really funky. I think bank 1 long term was - 18.2 and bank 2 was positive 18.2. Seemed really odd- James Kiger
- Post #3
- Forum: Engine Performance + Maintenance
-
J
350 vortec issue.
Hi all, looking for some help diagnosing an issue with my van. The van has been sitting for 4 years. I got it home and got it running, it had 0 fuel pressure. New pump and filter, starts right up. Van ran rough at first but slowly cleared up for the most part. The van is running slightly rough...- James Kiger
- Thread
- Replies: 8
- Forum: Engine Performance + Maintenance
