Recent content by ELBscorp65
-
plastic repair
If you use a mixture of about 25% MEK & 75% acetone to dissolve the ABS in you will get a better cement. On motorcycle fairings I tape the backside then use an old soldering iron to create a V in the top side much like you would have to weld steel. Fill that in with your cement and once it dries...- ELBscorp65
- Post #7
- Forum: OEM and Custom Interiors
-
88-98 Bucket seat alternatives
True, but I would like to find something that wasn't too much of a PIA. I'm going to have to look and try out several, the Honda Odyssey seats and console look good in pictures.- ELBscorp65
- Post #444
- Forum: OEM and Custom Interiors
-
88-98 Bucket seat alternatives
Hopefully I haven't overlooked this but has anyone tried BMW, Lexus, Infinity, Audi Or anything similar? I saw one post I believe where someone put Mercedes seats in. The main reason I'm asking is that the LKQ Pick a Part near me charges the same price $25.58 each for bucket seats whether is...- ELBscorp65
- Post #442
- Forum: OEM and Custom Interiors
-
Hello from Georgia
We are probably close then. I am in Northwest corner just below Chattanooga TN. Right now I have the dash torn out of it. I'm going in the morning to look at some seats. 2003 Grand Am and a 99 Malibu both sets are grey and look good in pictures. Guy told me $50.00 either set if I pull them, he...- ELBscorp65
- Post #4
- Forum: Introduction
-
Hello from Georgia
Hi, just got around to joining. I've been lurking off and on for a while gathering info. Here is the build sheet on mine 1GCGC33RXWF0XXXXX 168.5 CC30943 AM7 Rear Seat Folding A52 Seat, Front Bench B85 Moldings, bodyside B96 Molding...- ELBscorp65
- Thread
- Replies: 7
- Forum: Introduction
