tattooed4life
HMFIC
I have a few ways I have removed them before
1) If there is any type of head left I use my cordless impact, the hammering sometimes breaks them loose.
2) I have a Matco impact screwdriver, you put as much down pressure as you can on it and while twisting the way you want the screw to go hit it with a hammer a few times and it may break them few.
3) And the last resort for those stubborn son of a bitches is an easy out-one of the best sets of tools I have ever purchased.
After removing my factory srews i went to the local hardware store and picked up new screws of the same diameter and length but i got the in stainless steel with a 1/4" nut driver head instead of phillips.
1) If there is any type of head left I use my cordless impact, the hammering sometimes breaks them loose.
2) I have a Matco impact screwdriver, you put as much down pressure as you can on it and while twisting the way you want the screw to go hit it with a hammer a few times and it may break them few.
3) And the last resort for those stubborn son of a bitches is an easy out-one of the best sets of tools I have ever purchased.
After removing my factory srews i went to the local hardware store and picked up new screws of the same diameter and length but i got the in stainless steel with a 1/4" nut driver head instead of phillips.