evilunclegrimace
Does not always play well with others
Cannot get past a certain spot on reseating my harmonic balancer -- it gets to the same spot (only halfway home) and just STOPS. All forward progress halts and it's either the installer bearing that is going to implode or I am going to commit the unpardonable sin of stripping out the crank snout threads. I have had to remove it twice already and start all over, both times inspecting the inner and outer metal surfaces of the concerned two mating surfaces. They are coated in super lube and are clean... but they look dull, like they need polishing. Looking for some direction here on how to properly polish these two surfaces (snout and HB inner track) and what works best for lubrication (have heard everything from motor oil to white lithium to silicone RTV). Could really use some help here guys -- I need this all to go back together tomorrow. what grit sandpaper (2000?)? Dremel polishing bit with jewelery polishing paste? Thanks.
What are you using to install the HB? A bolt or an actual Balancer instillation tool? If you are using a bolt STOP!! You are most likely bottoming the bolt in the crank snout. The balancer MUST be installed with the proper tool. DO NOT try and drive the balancer on with a hammer as you can severely damage the thrust bearing.