Majoraslayer
I'm Awesome
I picked up a pre-owned GM Performance Parts TBI intake for Vortec heads, so it didn't have any paperwork with it. An Edelbrock Vortec intake install manual I found online says to torque to 11 ft-lbs, so I used those instructions and the torque sequence that was included. However, I'm seeing conflicting information online (as seems to be usual), so I want to verify this should be the right torque for this intake. Most of the disagreement I've found seems to vary based on which gasket is used. I'm using the Fel-Pro MS90131-2 intake gaskets, which feel like a thick plastic with in-laid rubber mating surfaces. Would anyone more experienced be able to verify my torque spec is correct for the intake and gaskets I used?