LeFrostiPine
Newbie
Heya! My lower balljoint is shot, so I went to replace it with some Autozone ****. However, after 3 attempts to install, the bottom balljoint's lip looks bent, even though it's fully seated. The original one was fully flushed. I've attempted to even it out, but I've bent two out of three autozone balljoint presses in the process. Does this look safe? I do not wanna tear apart the lower control arm and have it sent to a place that can press it in because of the torsion bar. Thanks in advance!
You must be registered for see images attach