My friends dad just sold me some ranch hand bumpers off of a 87 blazer for my 96 c1500. I was hoping they'd just bolt up but it is never that easy. The measurements aren't so far apart but i am just trying to figure out the best way to make these fit.
Front Frame Mount: 32 Inches
Rear Frame Mount: 36 Inches
New Front Bumper: 28 Inches
New Rear Bumper: 33 Inches
I can weld decent enough, but i am new to fabrication in general and am just looking for advice on the best and safest way to mount it.
Front Frame Mount: 32 Inches
Rear Frame Mount: 36 Inches
New Front Bumper: 28 Inches
New Rear Bumper: 33 Inches
I can weld decent enough, but i am new to fabrication in general and am just looking for advice on the best and safest way to mount it.