Wildblue19
I'm Awesome
Hello all,
I'm installing Q forms kick panels with a component 6.5/tweeter set that comes with a passive crossover. The crossover has the amp input and woofer/tweeter outputs. I would like to wire in the front 4 ohm 4x6 in series with the kick panel speakers, and have the 4x6 recieve full range signal via a splice between both the woofer and tweeter lines. Is this diagram valid?
My concerns are with the high and low signals being combined and mixing in a strange way, creating a notch filter due to the crossover curves. I am also unsure if the impedance will be 8 ohm or 2...
I understand the speakers could be wired in parallel creating a 2 ohm system; however that will over power them with my amp providing 220W rms @ 2 ohms.
I can clarify more if I'm missing pertinent info, still fairly new to car audio. Thanks!
I'm installing Q forms kick panels with a component 6.5/tweeter set that comes with a passive crossover. The crossover has the amp input and woofer/tweeter outputs. I would like to wire in the front 4 ohm 4x6 in series with the kick panel speakers, and have the 4x6 recieve full range signal via a splice between both the woofer and tweeter lines. Is this diagram valid?
My concerns are with the high and low signals being combined and mixing in a strange way, creating a notch filter due to the crossover curves. I am also unsure if the impedance will be 8 ohm or 2...
I understand the speakers could be wired in parallel creating a 2 ohm system; however that will over power them with my amp providing 220W rms @ 2 ohms.
I can clarify more if I'm missing pertinent info, still fairly new to car audio. Thanks!
Attachments
Last edited: