Diesel Don
Newbie
- Joined
- Apr 29, 2012
- Messages
- 15
- Reaction score
- 2
I am trying to do this to a '96 2wd to accomodate NNBS 18x8 6-lug wheels that I just bought. It seems cost prohibitive- I am calling junkyards and finding that the knuckle,hub,rotor, and caliper would be $290 PER SIDE. For used salvage parts.
Also will the ABS hook right up? edit: Yes.
I am also wondering what the effect on track width would be.
Since my new wheels are 31mm offset, I need to find a way to move the wheel mounting flange outwards about 1 and 1/4in. I'm assuming that the NBS truck spindle/hub would do this; because the NBS trucks are 31mm stock offset wheels.
At this rate, I seriously should start looking to buy an entire NBS donor truck for front end, and rear axle.
Also will the ABS hook right up? edit: Yes.
I am also wondering what the effect on track width would be.
Since my new wheels are 31mm offset, I need to find a way to move the wheel mounting flange outwards about 1 and 1/4in. I'm assuming that the NBS truck spindle/hub would do this; because the NBS trucks are 31mm stock offset wheels.
At this rate, I seriously should start looking to buy an entire NBS donor truck for front end, and rear axle.
Last edited: