My CV, ball joint and tie rod angles???

[SCOTTYINWV]

I've seen worse than mine, I'm cranked close to level with 2 in blocks. I still probably have a good 2 inches left to crank some more, not going to though...

What do yall think of my angles?

Front shot, not the best pic...

You must be registered for see images attach

Left front.

You must be registered for see images attach

Right front, probably up 2+/- inches where I'm on the sidewalk a bit...

You must be registered for see images attach

 

[lkfldredneck]

Yours are pretty bad, good is 3 or less boot sides touching.. you have 4..

And you dont have sway bar end links

 

[Jesse82nc]

Yours are pretty bad, good is 3 or less boot sides touching.. you have 4..

And you dont have sway bar end links

I was kind of wondering why it was missing those myself.

My tie rod angles are much more extreme than yours also.

 

[dowsewashere]

is that cranked to level? maybe new tbars would be in your future

 

[SCOTTYINWV]

Haha my links are behind the seat. Ain't got around to it yet...

New bars is planned, 250k on them.

She rides ok, not the best.
Wanting to do new control arms, TB's, keys, ball joints, tie rods, and full polly bushings front to rear this spring. Debating on a rcx 4" when I do, if I find a good deal ...

 

[Jesse82nc]

Haha my links are behind the seat. Ain't got around to it yet...

New bars is planned, 250k on them.

She rides ok, not the best.
Wanting to do new control arms, TB's, keys, ball joints, tie rods, and full polly bushings front to rear this spring. Debating on a rcx 4" when I do, if I find a good deal ...

What does it take? 5 minutes to install them, if that? Without your anti-sway bar attached, be cautious on turns for sure.

 

[SCOTTYINWV]

They're going on Monday or Tuesday. I haven't had the money for the bar bushings too so I been putting it off. I've had no issues driving though, handles ad good as my 08 1500 company truck... Just a stiffer ride.