grizzlybearx843
Newbie
Misfire and limp mode. I'm either blind or this harness is not the original harness for this truck. Any ideas?!
You must be registered for see images
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Vortec, my bad. I've been reading through forums all morning.Your 97 shouldn't have TBI, so if you swapped a TBI motor in that could be your problem. I know many of the sensors have different connectors between TBI and Vortec trucks.
There’s an Evap system solenoid and MAP sensor on the intake in that area, also the MAF sensor on the intake duct and an air temperature sensor right upstream of that.
I would think you’d be throwing a code, though, if any of those were unplugged.
Does it go to your light on the hood?
Sent from my iPhone using Tapatalk
I believe that’s plugged in. Peep that red clip on the connector behind the loose connector.Yupe, I do believe that should be your evap solenoid. There's one right there on my truck, it would be to the right of the connector in your picture.