Missouri Mule K30
Newbie
New crate engine, just doing some simple mods since I have to get engine in my commuter truck, 98 K1500. I am doing some simple blending on factory lower intake just for grins since it is already off.
Mostly all I can see is to take off either casting lines at runners, a little blending going into the runners, and at the spider location. Very minor around the outside edge as in reality there seems to be an eighth to quarter inch to really come off. But at what gain with stock cam. Do not want to spend wasted time as if the effort is fruitless why bother.
Some minor port matching can also be done on intake and not hurt flow into heads, as again you do not want to open more than entrance into heads.
What do the Troops think while I continue with search?
Mostly all I can see is to take off either casting lines at runners, a little blending going into the runners, and at the spider location. Very minor around the outside edge as in reality there seems to be an eighth to quarter inch to really come off. But at what gain with stock cam. Do not want to spend wasted time as if the effort is fruitless why bother.
Some minor port matching can also be done on intake and not hurt flow into heads, as again you do not want to open more than entrance into heads.
What do the Troops think while I continue with search?