I need measurement if possible

[Knuckle Dragger]

Can anyone measure from the end of the steering column to the top of the gear box input shaft for me on a 88-94? I don't need exact within a 1/2 inch will be fine I'm trying to ball park something and my truck doesn't have the stock column.

 

[Dropped88]

21" 1/4. This what you need.

Surface of gear box to flat surface of bottom of column

You must be registered for see images attach

You must be registered for see images attach

 

[Knuckle Dragger]

21" 1/4. This what you need.

Surface of gear box to flat surface of bottom of column

You must be registered for see images attach

You must be registered for see images attach

I can make that work, Awesome sir, thank you. No modifications to the column other than to make the jeep shaft work?

 

[Dropped88]

All I had to is grind a grove on the shaft on the column side so the pinch bolt could slide across and thats it

 

[Knuckle Dragger]

OK, I measured mine just like you did tahat one a

All I had to is grind a grove on the shaft on the column side so the pinch bolt could slide across and thats it

You are the man. I can get parts and make a plan now. The stock set up is about two inches different then what I have now. So I can keep the truck functional as I get the new shaft set up, thank you very much.

 

[Dropped88]

Your welcome. Its what this place is for