92 C1500 5.7L 700R4 3.08 8.5 inch rear end. Project vehicle, non-daily driver.
I had a leaking output shaft seal and also a leaking differential pinion seal so I pulled the driveshaft and this is what the slip joint looks like.
The next question is regarding the grease when reinstalling. The service manual calls for grease rated GM 6031-M for the splines. Can I use this same grease to coat the rubber part of the seal? Any problem using this Valvoline grease?
I had a leaking output shaft seal and also a leaking differential pinion seal so I pulled the driveshaft and this is what the slip joint looks like.
You must be registered for see images attach
I can run my finger nail across it and I don't feel that groove, but how bad is it really?The next question is regarding the grease when reinstalling. The service manual calls for grease rated GM 6031-M for the splines. Can I use this same grease to coat the rubber part of the seal? Any problem using this Valvoline grease?
You must be registered for see images attach
You must be registered for see images attach