NightRunner
Resident Junkman
Hello everyone! I know I've been relatively quiet on the forums lately as I've been busy with relocating myself to a new home and work has also gotten a bit much as well. However, now that the craziness has died down to a tolerable level I'm looking to get some more work done on the truck.
Previously, when repairing the front end I purchased a "less than quality" core support online. I'm not the biggest fan of it as most bolt holes have welds broken inside of them and I've basically had to rig the entire front end up in a way I'm not exactly comfortable with. So to fix this, I'm hitting a junkyard soon and pulling a core support from a truck with no front end damage. While I'm there however, I'm going to start looking for a clean W/T Grille and get it mounted up with new corner lights and headlights. I've been really off put with the front end of my truck just not matching the rest of it. It always seemed "newer" than the rest of the truck (especially with the 88-94 interior), so I'm looking to get a more retro look with the W/T setup.
My main question is, what's all involved with the wiring between composite and W/T? Since it's a single headlight, I'm trying to figure out how I'm supposed to combine my low and high beam wiring to go to one headlight instead of two. Same with the lower blinker lights. If anyone has some guidance to this, it would be greatly appreciated!
Previously, when repairing the front end I purchased a "less than quality" core support online. I'm not the biggest fan of it as most bolt holes have welds broken inside of them and I've basically had to rig the entire front end up in a way I'm not exactly comfortable with. So to fix this, I'm hitting a junkyard soon and pulling a core support from a truck with no front end damage. While I'm there however, I'm going to start looking for a clean W/T Grille and get it mounted up with new corner lights and headlights. I've been really off put with the front end of my truck just not matching the rest of it. It always seemed "newer" than the rest of the truck (especially with the 88-94 interior), so I'm looking to get a more retro look with the W/T setup.
My main question is, what's all involved with the wiring between composite and W/T? Since it's a single headlight, I'm trying to figure out how I'm supposed to combine my low and high beam wiring to go to one headlight instead of two. Same with the lower blinker lights. If anyone has some guidance to this, it would be greatly appreciated!