2TooManyTrucks
Newbie
All windows work fine from their respective switches.
The master switch on the driver's door controls the passenger rear just fine as well.
The master switch won't roll the passenger front window down (will roll it up though).
The opposite goes for the driver side rear. That one rolls down but not up.
It's not the master switch as I swapped it out with a new one and am having the same problem.
If I try to roll down the passenger front or roll up the driver rear, with the driver's master, the whole electrical system has a noticeable drain (the HVAC fan slows down even).
Today while swapping switches, I noticed that with the engine off, the wire feeding the master switch get hot.
With the engine running, this is not the case.
Obviously its an issue with wiring leading to the master switch, I just don't know how to test it further to figure out the problem.
Ideas?
The master switch on the driver's door controls the passenger rear just fine as well.
The master switch won't roll the passenger front window down (will roll it up though).
The opposite goes for the driver side rear. That one rolls down but not up.
It's not the master switch as I swapped it out with a new one and am having the same problem.
If I try to roll down the passenger front or roll up the driver rear, with the driver's master, the whole electrical system has a noticeable drain (the HVAC fan slows down even).
Today while swapping switches, I noticed that with the engine off, the wire feeding the master switch get hot.
With the engine running, this is not the case.
Obviously its an issue with wiring leading to the master switch, I just don't know how to test it further to figure out the problem.
Ideas?