Brake lights dont work after changing steering column

[__CHI__]

Not sure what went wrong while my dad and i changed the column,hooked everything back up where it should go and everything but the brake lights work,got power going to them but wont come on,brand new brake light switch was put in a few months ago and never had an issue..I'm stumped yall
By the way,the vehicle is a 95 tahoe

 

[__CHI__]

Nothing?..

 

[east302]

Does the third brake light work?

Diagram below is for a 1998, but I'd bet that it's similar or the same as a 95.

When the brake is pressed, the brake light switch closes and you'll get voltage to the third brake light at splice #220. From there, it goes through the turn/hazard switch to the rear brake lamps.

Here are the diagnostics, it starts with seeing if you have voltage at the brake switch.

You must be registered for see images attach

You must be registered for see images

You must be registered for see images attach

You must be registered for see images

Connector C266:

You must be registered for see images

You must be registered for see images

You must be registered for see images

You must be registered for see images

Sent from my iPhone using Tapatalk

 

[__CHI__]

Thanks man,3rd light wasnt working but got it sorted out now

 

[RussKincaid]

OP, Can you elaborate on what the exact problem and what the solution was? It drives me batty when I go looking for a thread where someone with the same problem I'm having, only to find that the thread dies without any info on the actual problem or solution. Thanks!