Adjustable Tap Holders

[Papablunt]

Due to minimal clearance where I'm working, I had to pick up some tap holder sockets with 3/8" drive. These made it so much easier and less finicky than the typical tap holder with handles.

You must be registered for see images attach

You must be registered for see images attach

 

[TechNova]

I have one of those with 3/8 square on the end to turn it with a ratchet. It also has a taper on the end to mate it to a live center on a lathe to start the tap straight by hand.

 

[Papablunt]

I have one of those with 3/8 square on the end to turn it with a ratchet. It also has a taper on the end to mate it to a live center on a lathe to start the tap straight by hand.

Sure makes things easier!